Guitars
A guitar’s pickups, switch, volume and tone, with the cable and amp input, solved part by part. Flip the switch, split a coil, turn the knobs and watch the curve. Pin a setting to compare, change any part, and listen.
Swipe sideways for the whole drawing. Tap a part to change it. The pickups are on the left, and the cable and the amp input hang on the right.
At this setting
0 dB is the pickup’s raw voltage, before the coil, knobs, cable and amp input shape it. The peak up top is the pickup’s resonance.
Pin this curve keeps what the graph shows, up to three pins in their own colors. Pins stay when you switch guitars, so you can lay a Strat’s neck pickup over a Les Paul’s. In a sweep, the lightest line is the knob at 0 and the darkest is 10.
Listen
The amp input
Driven by
What the cable plugs into
Warnings The summary above the graph turns red if the guitar can’t be solved as set, usually from a part at zero or a shorted pot track.
How this tool works We solve each guitar with the circuit bench’s engine at 161 frequencies from 20 Hz to 20 kHz, cable and amp input included. Each pickup is modeled as a voltage source with its coil’s resistance, inductance and winding capacitance, and a humbucker as two coils coupled together. With several pickups on, the output from each pickup is solved with the other pickups’ voltages set to zero, and the results are added.
The curves are for small signals. They leave out the distortion a pickup’s magnets add on hard picking, the width of string each pickup senses, and the body and neck. The string you hear when you press Play includes the first two. Coil values are measured where a part’s description says so, typical otherwise. For an amp’s tone stack, try the tone stack and filter tool. To play a guitar into a whole pedal or amp, use the circuit bench.
A pickup into its volume pot and the amp starts out as a coil and a resistor, a low-pass. The corner calculator shows that corner before the capacitance turns it into a peak.