Gyrator calculator

A gyrator is a follower, a cap and two resistors that act like a coil to ground. Design one from the parts you have or from the inductance you want, built with an op-amp or a single transistor, and see where it stops acting like a coil.

Parts

The coil it acts like

Setting L changes

Impedance

Resonance with a cap in series

How hard it can be driven

How a gyrator acts like a coil

The cap and Rg pass the voltage at the gyrator’s terminal on to the follower: only part of it at low frequencies, and nearly all of it at high frequencies. The follower copies that voltage to the far end of Rs. At high frequencies both ends of Rs are at nearly the same voltage, so little current flows through it. At low frequencies the far end stays near ground, and more current flows. Less current as the frequency rises is how a coil behaves. With a perfect follower the inductance is L = Rs × Rg × C. The coil it imitates has Rs in series with it and roughly Rg across it.

The circuit acts like a coil only between two frequencies. Below fLo = 1 / (2π Rg C) it looks mostly like Rs. Above fHi = 1 / (2π Rs C) it looks mostly like Rg. Its Q is highest midway between the two (at the square root of fLo times fHi), where Q is about half the square root of Rg / Rs. The bigger Rg is compared with Rs, the more the circuit acts like a real coil.

Op-amp follower The op-amp’s limited speed adds a third limit. It is near the square root of the op-amp’s gain-bandwidth product times fLo. Around that frequency the impedance peaks, and above it the circuit stops acting like a coil. With a TL072 and the starting values the limit is about 3.9 kHz, well below fHi. That is fine for bass and mids, where most gyrators are used. The op-amp also has to supply all of the coil’s current through Rs, so with a small Rs and a large inductance it runs out of current at a low signal level.

Transistor follower The formula is the same, but a single transistor falls short of a perfect follower in two ways. First, its gain is slightly under 1. The shortfall is about 26 mV divided by the DC voltage across the emitter resistor, and it adds a loss that grows with frequency. Second, the coil’s current flows through the transistor, so the base needs that current divided by the transistor’s gain (beta), and the base current has to come through Rg. In this model a 2N5088 at about 1.7 mA reaches a Q of about 4 at best, with Rg around half of beta × Rs. On the negative half of the swing it can only pull as much current as its emitter resistor carries at idle. That is fine for broad, gentle peaks. For a narrow peak, use an op-amp. The gyrator’s terminal is at the emitter’s DC voltage, so it needs a cap in series, which it usually has.

With a cap in series Most gyrators are used this way, as a graphic EQ band or a power amp’s resonance control. The cap and the coil resonate at f = 1 / (2π √(L C)), and the Q is √(L / C) divided by the series resistance. Enter any other resistance in the branch in the second field.