Transistor bias calculator

Measure a JFET’s Idss and Vgs(off), or a transistor’s gain and leakage, and enter the voltage you want on the drain or collector. Get the resistor that sets it, rounded to stock values, and see how far a different part of the same type would move it.

The part

Leakage read as

What you want

Held

Find
Stock values

Swipe sideways for the whole drawing. Tap a part to jump to its value. The part in blue is the one found. The red numbers are DC voltages to ground at the stock values.

Stock values

Across the part’s spread

How biasing works

A transistor stage needs its output resting somewhere between ground and the supply, so the signal can swing both ways before it clips. About half the supply is the usual target. Set it lower or higher and one side of the wave runs out of room first. Builders tune that by ear on fuzzes and boosters.

The JFET The JFET’s drain current flows through the source resistor and raises the source above the gate, which the gate resistor holds at 0 V. That makes the gate negative compared with the source, and a negative gate cuts the current back. The square-law formula says by how much: Id = Idss (1 − Vgs / Vgs(off))². The calculator works in three steps. The drain voltage you want and the drain resistor set the current. The gate voltage that passes that current comes from the formula. The source resistor is that voltage divided by the current. Idss and Vgs(off) can differ by several times between two JFETs with the same part number, which is why builders measure each JFET or fit a trimmer in place of the source resistor.

The BJT The collector current is the base current times the gain, plus the leakage: Ic = hFE Ib + Iceo. With collector feedback, the base current comes from the collector through a resistor. If the collector current rises, the collector voltage drops, and that lowers the base current. The bias is steadier than with a fixed base resistor, but it still moves with the transistor’s gain. A base divider with an emitter resistor is the steadiest of the three, because the emitter resistor sets the current more than the gain does.

Leakage Germanium transistors pass some collector current with no base current at all. A tester measures the leakage with the base disconnected (Iceo). To measure gain, the tester feeds in a known base current and reads how much the collector current rises, with the leakage subtracted. Leakage acts like extra base current, so it pulls the collector voltage toward the emitter. It about doubles every 16 °F. Silicon parts leak a few nA, too little to matter here.

Stock values The exact resistor almost never comes in a stock value. The table lists the stock values on either side of it and where each puts the output, so you can pick the one nearer what you want. Under the spread table is a fixed resistor and a trimmer in series that together cover every part in the table.

Warnings Red flags a voltage the circuit can’t reach with any value of the resistor, a JFET pushed out of its saturation region, a transistor saturated or nearly off at the stock values, or the solver not settling.

How this calculator works The answer comes from the same engine and part presets as the bench and the transistor and op-amp stage tool. The stage is set up in the engine and its DC voltages are solved. Then the resistor is adjusted, coming closer by half each time, until the output is at the voltage you want. The textbook hand calculation is shown beside it. The two differ slightly, because the engine’s part models include effects the hand formulas leave out, such as the small change in current with collector or drain voltage. The figures you measured replace the preset’s values. Everything else about the part comes from the preset, so treat the answer as a starting point. The spread rows and the chart are also solved in the engine, with the stock values.