Clippers

Diodes that flatten the top and bottom of the wave, as in almost every overdrive and distortion pedal. Pick where they go and which diodes, then see where clipping starts, the clipped wave and its harmonics.

Sine at

Swipe sideways for the whole drawing. Tap a part to jump to its value.

Transfer curve

Output, one cycle

Harmonics

evenodd dB below the fundamental, 2nd to 10th

All values

Reading the curve

The transfer curve shows the output voltage for each input voltage, with the input held steady at each one. A straight line means no clipping. Where the curve bends over, the diodes are conducting, and the flatter it gets, the harder the clipping. The dashed line is the clipper with the diodes taken out, and the circles mark where the output falls 1 dB under it, which is where clipping starts. The blue stretch is the part of the curve the sine moves over.

Each diode starts to conduct at its knee, about 0.6 V for silicon, 0.2 to 0.3 V for germanium and Schottky diodes, 1.6 to 2 V for a red LED and more for green and blue. Diodes in series add their knees. The dashed lines across the curve show the voltage where each string passes 1 mA. Germanium and LED knees are softer, so the curve bends over a wider range of input.

Uneven pairs With different diodes on each half, one side clips at a higher voltage than the other. The wave turns lopsided and even harmonics appear (orange), which usually sounds rounder. With a coupling cap ahead of the diodes, the cap charges until as much current flows through it one way as the other. That shifts the whole wave slightly toward the side that clips later.

To ground The series resistor and the diodes make a divider that changes with the level. Below the knee the output follows the input. Above it the diodes pull more current and hold the output near their knee, so the clipping is hard. A larger resistor lets less current through the diodes, so the output levels off slightly lower. A cap across the diodes rounds the edges. A germanium pair passes some current even at rest, which trims the level slightly before it clips.

In op-amp feedback Below the knee the stage has its full gain, 1 + Rf / Rg. Once the diodes conduct, they bypass Rf and the gain falls toward 1, so the output can’t rise much more than one diode drop above the input. The clipping is softer than with diodes to ground, and the unclipped input signal is still part of the output. With Cg in the gain leg, the gain also falls toward 1 at low frequencies, so the low notes clip least.

In series The diodes pass nothing until the input is over their knee. Small signals vanish, and every cycle loses a slice around zero.