Fuzz pairs
The Fuzz Face and the Tone Bender are each two transistors tied together by feedback, with a third in front on the Tone Bender Mk II. Change each transistor’s gain and leakage, a bias resistor or the room temperature, and see where the collector voltage goes and what the fuzz does with it.
Swipe sideways for the whole drawing. Tap a part to jump to its value. The red numbers are DC voltages to ground.
Output at the amp, one cycle
Collectors, one cycle
Harmonics
evenodd dB below the fundamental, 2nd to 10th
All values
How the pair works
The first transistor of the pair has no bias network of its own. Its base is fed from the second transistor’s emitter through the 100 kΩ feedback resistor, and its collector drives the second transistor’s base directly. If the second transistor pulls more current, its emitter rises, the first transistor turns on harder, its collector falls, and the second transistor is turned back down. The pair settles where the two effects balance. The second transistor’s collector voltage is the one number that tells you where that is.
The collector voltage Builders set the second transistor’s collector with a trimmer in place of the 8.2 kΩ (or by changing the first collector’s resistor). About half the battery is the usual starting point: −4.5 V on a germanium PNP fuzz, 4.5 V on a silicon one. Away from the middle, one side of the wave runs out of room first and clips before the other, which adds even harmonics. Players set it by ear from there. The dashed line on the chart is half the battery.
Gain and leakage On the Fuzz Face the first transistor’s gain moves the bias the most. The second one’s gain matters far less, because the feedback holds its current. Germanium transistors leak: some collector current flows with no base current at all, and it about doubles every 9 °C (16 °F). A little leakage acts like more gain. A lot of it turns the first transistor on hard and shoves the second collector toward the battery. That’s why vintage germanium fuzzes were matched by hand and why they drift on a hot stage.
The guitar volume The pair’s input impedance is only a few kilohms, so the guitar’s pickup and volume pot are part of the circuit. Turning the guitar down puts the pot’s resistance in series with that low impedance. That cuts the signal reaching the first transistor’s base far more than the same turn would cut it into an amp. That’s the cleanup these fuzzes are known for. Most of it comes between 10 and 7, where an audio-taper pot already has three quarters of its track in series. It works less well after a buffer.
The Tone Bender Mk II Its Q1 is a booster in front of the pair with only a resistor from its base to ground. Its only bias current is its leakage, multiplied by its gain, so it needs a leaky transistor. With a less leaky part it barely conducts.
Warnings Red flags the second collector within half a volt of the battery or of its emitter at rest, the first transistor saturated, the Tone Bender’s Q1 nearly off or saturated, or the solver not settling.